info@lingtong.co    +8613858215468
Cont

Have any Questions?

+8613858215468

video

Refrigerator Defrost Thermostat Fit For Whirlpool

ELTH-005 28149 Refrigerator Defrost Thermostat Fit for Whirlpool
Defrost thermostat ELTH-005 28149 is located inside the freezer compartment either directly mounted to the evaporator or indirectly mounted to the evaporator.
The function of Defrost bi-metal thermostat ELTH-005 28149 is to clip onto the evaporator and protect the evaporator from overheating during the defrost cycle.
Send Inquiry

Product Introduction

PRODUCT-INFORMATION

The replacement part is made from durable high-quality material and well-tested by the manufacturer - Meet OEM standards - Ensure long-lasting and effective operation. To do this installation the tools you will need include a 1/4 inch nut driver, a pair of wire strippers and crimpers, and a heat gun. This part fixes the following symptoms: Fridge too warm | Freezer not defrosting | Freezer section too warm | Frost buildup.

The defrost thermostat protects the evaporator from overheating during the defrost cycle. The defrost thermostat monitors the temperature of the evaporator coils. When the coils drop below a set temperature, the thermostat sends power to the defrost heater. If the defrost thermostat is defective, the refrigerator will not defrost. To access the defrost thermostat for this repair, you will need to remove your freezer shelves, as well as the back panel of your freezer. To complete this repair, you will need a 1/4-inch nut driver, a set of wire strippers and crimpers, and a heat gun or blow dryer. Before you begin this repair, be sure to disconnect the power source from the appliance.

2(001)


SPECIFICATION

ltem NO

ELTH-005 28149

Use

Defrost/Temperature control/Protection

Appliance

Refrigerators, Freezer

Reset type

Automatic

Basic material

Bakelite, Epoxy Resin, PA

Electric rating

250V 10A

Action temperature range

-30°C~90°C

Differential

According to the requirement

Insulation resistance

≥100MΩ

Tolerance

Refer to the regulation

Life cycle

100,000 times

Contact material

Silver

Dielectric Strength

Parts between electriferous components and non-electriferous ones can bear 2000V (3750V for Reinforced insulation type) 50Hz AC current, which is nearly sine wave, for one minute as bearing test. Resulted no breakdown, no flashover.

Insulation Resistance

With a DC 500V megger, borne DC 500V, the tested value is over 10MW.

Resistance Between Terminals

Below 50mW

Temperature characteristics

Normal close, Normal open

Maximum Ambient Temperature

90°C

Diameter of Bimetal Disc

F12.7mm(1/2″)

Wire Leads

Color: Red Length: customized

Terminal type

Customized (Refer to our specification)

Cover/Bracket

Customized (Refer to our specification)

Sample Price

Free sample USD 50 freight charge, refund after mass order


PRODUCT-DETAILS

ELTH-005 28149 bimetal para refrigeradores_

APPLICATION-SCENARIO

(001)


How does a fridge freezer thermostat work?

The thermostat controls the cooling process by monitoring the temperature and then switching the compressor on and off. When the sensor senses that it's cold enough inside a refrigerator, it turns off the compressor. If it senses too much heat, it switches the compressor on and begins the cooling process again.s with some basic hand tools, and the cost is minimal when compared to a service call to a technician or a new refrigerator.


FAQ_01

Hot Tags: refrigerator defrost thermostat fit for whirlpool, suppliers, manufacturers, factory, customized, wholesale, bulk, in stock, free sample, bimetal thermostat for refrigerator, Fridge Door Control Switch, Refrigerator Defrost Heater Replacements WR51X10055, Refrigerator Fan Motor Suitable, WHIRLPOOL refrigerator door switch, refrigerator door light switch

Send Inquiry

(0/10)

clearall