info@lingtong.co    +8613858215468
Cont

Have any Questions?

+8613858215468

video

PL005 04571 Refrigerator Bimetal Defrost Thermostat

PL005 04571 Refrigerator Bimetal Defrost Thermostat Replacement Whirlpool Kenmore
The function of the defrost bi-metal thermostat is to clip onto the evaporator and protect your evaporator from overheating during the defrost cycle. If your refrigerator does not defrost properly you can test both the thermostat and the heater to figure out which part is at fault. For this repair, you will need a Phillips screwdriver, a 1/4 inch nut driver, a flat blade screwdriver, a pair of wire strippers, a roll of electrical tape, and a few butt splice connectors.
Send Inquiry

Product Introduction

PRODUCT-INFORMATION

Description:

1. Defrost thermostat PL005 04571 is located inside the freezer compartment either directly mounted to the evaporator or indirectly mounted to the evaporator.

2. The function of Defrost bi-metal thermostat PL005 04571 is to clip onto the evaporator and protect the evaporator from overheating during the defrost cycle.

3. If the temperature of the evaporator exceeds the defrost thermostat setting the defrost heaters are turned off.

4. If you have ice building up in your freezer, or if your freezer is getting too warm during the defrost cycle you may need to replace the bi-metal defrost thermostat.

5. If your refrigerator does not defrost properly you can test both the thermostat and the heater to figure out which part is at fault.

2(001)


SPECIFICATION

ltem NO

PL005 04571

Use

Defrost/Temperature control/Protection

Appliance

refrigerators, freezer

Reset type

Automatic

Base material

stainless steel, epoxy resin,silver,copper

Voltage

120V/240V

TEMPERATURE

OPEN:60F° CLOSE:32°F

Differential

According to the requirement

Cycle of endurance

100,000

Tolerance

Refer to the regulation

Resistive amps

10A / 5A

Contact material

Silver

Dielectric Strength

Parts between electriferous components and non-electriferous ones can bear 2000V (3750V for Reinforced insulation type) 50Hz AC current, which is nearly sine wave, for one minute as bearing test. Resulted no breakdown, no flashover.

Insulation Resistance

With a DC 500V megger, borne DC 500V, the tested value is over 10MW.

Resistance Between Terminals

Below 50mW

Temperature characteristics

Normal close, Normal open

Maximum ambient temperature

90°C

Diameter of bimetal disc

25.4mm(1″)

Line

Color: white/brown/yellow/blue Length: customized

Terminal type

Customized (Refer to our specification)

Cover/Bracket

Customized (Refer to our specification)

Sample price

Free sample,USD 50 freight charge.Refund after mass order


PRODUCT-DETAILS

1_

APPLICATION-SCENARIO

(001)


What starts a refrigerator into defrost cycle?

A defrost cycle runs when the heating component attached to the evaporator coil is activated. During the defrost, the coil runs hot to melt accumulated frost and ice, which allows the evaporator to resume its optimal heat absorption and freezer cabinet cooling functions.


FAQ_01

Hot Tags: pl005 04571 refrigerator bimetal defrost thermostat, suppliers, manufacturers, factory, customized, wholesale, bulk, in stock, free sample

Send Inquiry

(0/10)

clearall