The price, principle, and how to disassemble the washing machine clutch have been covered before, so it is great to explain these aspects again, and there will be some repetition. Therefore, the editor feels that it is better to concentrate on explaining some new knowledge content, which is not yet available before. This will be better, so that everyone can learn new content, so as to better understand the product of washing machine clutch, and increase this Some knowledge in this area for later use.
How should we judge the failure of the washing machine clutch? This is also what everyone cares about, so the following editor will analyze it in detail.
To know if there is a problem with the clutch, we can perform the following checks as follows:
When the pawl can move the ratchet wheel normally, turn the big pulley by hand. If it cannot turn, then there is a problem with the planetary reducer, which can be caused by a shaft holding failure, or the planetary gear may have lost its teeth and become stuck. Phenomenon. But if it can rotate, it depends on whether the pulsator can rotate. If it can't turn, then check whether the inner hole of the pulsator is polished, if yes, replace the deceleration clutch.
If the second clutch failure causes the washing machine to not be dehydrated, the reasons are as follows:
Reason 1: The square wire clutch spring is broken or damaged.
Reason 2: The gap between the clutch sleeve or the square wire clutch spring is too large.
Reason three: The brake belt was not released in time.
